Do bazy wiedzy

Forgot password for the user interface of FRITZ!Repeater

You forgot the password for the FRITZ!Repeater? ✔ Here you can find out how to log into the user interface again.

You can protect the user interface of your FRITZ!Repeater against unauthorized access with your own password.

If you are using the FRITZ!Repeater as the Mesh Master and you changed the default password on the underside of the repeater but then forgot the new password, reset the password or load the FRITZ!Repeater's factory settings. Then you can log in again and set a new password. For security reasons, you can only reset the password when you access the user interface from the home network.

If you did not assign a password when setting up the FRITZ!Repeater as a Mesh Repeater, after setting it up you must use the password and, if applicable, the username of the Mesh Master (FRITZ!Box or FRITZ!Repeater) to log in.

1 Using the Mesh Master's password

If you did not assign a password for the repeater's user interface, you must use the password of the Mesh Master (FRITZ!Box or FRITZ!Repeater) and, if applicable, its username to log in. Log on with the Mesh Master's password.

2 Resetting the password

If you are offered the option of sending a push service mail, have an email with a link to access the user interface sent to you that you can use to reset the password:

  1. Open the user interface of the FRITZ!Repeater.
  2. Click the "Forgot your password?" link.
  3. Click the "Send push service mail" button. If the button is not displayed, the "forgot password" push service is not configured.
  4. Call up the email with the same device you used to request the push service mail and follow the instructions in the email. If you did not receive an email, either the email account information entered for the push service is not correct, or the repeater is not connected to the internet.

    Important:The email may have been classified as unsolicited advertising (spam). In this case, also check the spam folder of your email inbox.

3 Loading the factory settings and reconfiguring the FRITZ!Repeater

If you are not offered the option of sending a push service mail or you did not receive the push service mail, you cannot open the user interface again until you load the factory settings:

Loading the factory settings

  1. Push and hold down the Connect button for about 15 seconds.
  2. The Connect LED now indicates by alternately flashing and lighting up that the factory settings are being loaded and that the FRITZ!Repeater is being restarted. This process may take several minutes.
  3. The Connect LED flashes continuously for at least 1 minute as soon as the factory settings have finished loading.

Setting up the FRITZ!Repeater

  1. Reconfigure the FRITZ!Repeater according to our guide, depending whether you are using the FRITZ!Repeater without a FRITZ!Box or are using the FRITZ!Repeater with a FRITZ!Box.